Marking laser object issue - brand FOBA

Hello,

 One issue I have is that the marking laser object is working incorrectly, after executing 'Start Job' command, the CheckUnitDone is in the running status, cannot step out from the running to ready. Here I attached some screenshots. need your help, thank you~

Object version: 1.3.0.0

Peripheral version:1.3.0.0

Screenshots.zip
549.67KB
Best reply by Düscha

what laser you used

MarkUs or ultimate.

MarkUs is the System with windows and owner PC.

Ultimate is a smal box with Linux system.

Ultimate not supportet all cmd. And I see you used ParImm.StopJob

I dont know this supportet from the ultimate laser version.

Is there a reason why you use StopLaser?

I have never seen in a marking application that a laser process had to be stopped from the outside.

So until today a small bug in the command was not detected which causes the command not to finish.

 

Our Helpdesk send you the new version.

View original
2 replies
Resolved